EE 476: Laboratory 5

Digital Thermometer with fan

You will build a digital thermometer which displays temperature on a LCD display and controls a fan with user-selectable turn-on temperature.

The LM34 temperature sensor produces a voltage output of 10 mV/degree F. You will need to perfrom an analog-to-digital conversion using the mcu to read the voltage. For optimum accuracy, you will need to amplifiy the output of the LM34 by a factor of 2 (using an LMC7111 opamp) before feeding it into the A/D converter. Filtering the opamp output may lower spike noise. Use the scope to decide if you need a filter. The most accurate way to use the ADC requires that you use the internal voltage reference. For each different mcu that you use, you will need to measure Aref and use the measured value in your code.

You will need to drive a fan from the mcu. Fans have motors which can cause nasty inductive spikes to wipe out the transistors in the mcu port. The circuit shown below is fairly safe. An optoisolator completely isolates the MCU from the motor. The diode placed across the motor shorts out spikes when the motor is turned off. The pinout of the 4N35 optoisolator is also shown.

Assignment

Write a program and construct a circuit which will

• Measure room temperature with an LM34 and convert the output voltage to a number using an A-to-D converter program running on the mcu.
• Format the termperature and display appropriate messages on an LCD.
• When the user briefly presses one of two buttons (labeled increase and decrease), display the fan set point temperature. Make the default fan set point temperature (at RESET time) be greater than room temperature.
• If the user holds either button down for more than 1/2 second, the set point is modified in the appropriate direction and displayed.
• If the actual sensor temperature is above the set point, turn on the fan.If the fan is pointing at the LM34, it should cool the tempature sensor and turn itself off.

You will demo all the features above to your TA.

Your written lab report should include:

• A schematic of the circuit you built.
• A summary of the accuracy of your measurements. You should look at noise on the opamp output using the scope. You should also look at the stability of the A/D converter at constant voltage input.
• A heavily commented listing of your code.